
To light the burner:
1. Push the knob for the necessary burner
down completely and turn it to the
maximum position
. When you push
the knob, the spark generator starts
automatically.
2. Keep the knob pushed for approxi-
mately 10 seconds. This lets the ther-
mocouple warm up. If not, the gas sup-
ply is interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are
in the correct positions.
1
2
3
4
1
Burner cap
2
Burner crown
3
Ignition candle
4
Thermocouple
Warning! Do not keep the control
knob pushed for more than 15
seconds.
If the burner does not light after 15
seconds, release the control knob, turn
it into off position and try to light the
burner again after minimum 1 minute.
Important! You can light the burner
without electrical device (e.g. when there is
no electricity in the kitchen). To do so, put
the flame near the burner, push the related
control knob down for 10 seconds and turn
it counterclockwise to the maximum gas
release position.
If the burner accidentally goes out, turn
the control knob to the off position and
try to light the burner again after mini-
mum 1 minute.
The spark generator can start automat-
ically when you switch on the mains,
after installation or a power cut. It is
normal.
Warning! Always turn the flame down
or switch it off before removing the
pans off the burner.
Warning!
Cooking with "Durotherm"
cookware
The double-walled "Durotherm"
cookware is equipped with removable
warming bottom. Remove the bottom
before placing the cookware on the
pan support.
IN CASE OF SMELL OF GAS:
1. Do not light fire, do not smoke.
Do not activate any electrical switches,
devices, etc.
Do not use any telephone in the same
house.
2. Close main gas tap and all burner regu-
lators, no other manipulations!
A) Press in lower flap (1) and open (2):
1
2
A
B) Inside press in main gas tap (1) and
close it by turning right until you feel
the resistant (2). Both indicators on
the tap will turn from green into red
(3):
B
2
1
3
8 electrolux
Comentarios a estos manuales