Electrolux ControlBox24/7 Manual de usuario descargar pdf (Pagina 13)

REMOTE CONTROL YOUR HEAT PUMP

Flexible control (Only works with Electrolux heat pumps)

Once ControlBox24/7 has been set up for the correct heat pump model, you can control your heat pump by sending text message to the unit.

Follow the instructions below for giving the command. Please note that this command will start the heat pump even when it is switched off.

The modes which can be selected on the heat pump are: HEAT, COOL and DRY.

To send a setting to the pump WITHOUT specifying a fan speed, enter the following:

<MODE><space><TEMPERATURE> Example: HEAT 20

In the example above, the following setting is sent to the heat pump “Heat, 20°C, automatic fan speed”

An alternative to send to the heat pump is to state a speciﬁ c fan speed by adding a colon after the temperature, and then entering the desired fan

speed. See the following:

<MODE><space><TEMPERATURE>:<FAN SPEED> Example: COOL 18:2

In the example above, the following setting is sent to the heat pump “Cool, 20°C, fan speed 2”.

A list of the available settings for the various models is shown below.

*DRY = nonadjustable fan speed.

EHEAT ECOOL CHEAT CCOOL HXHEAT

COOL 16-30 16-30 18-32

DRY 16-30 * 16-30 * 16-30 * 16-30 *

HEAT 8, 16-30 8, 16-30 8, 16-30 8, 16-30

Fan speed 0 (auto), 1-5 0 (auto), 1-5 0 (auto), 1-3 0 (auto), 1-3 0 (auto), 1-3

TIP!

By sending the OFF command, you

can also switch off the heat pump.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Sin comentarios

Electrolux ControlBox24/7 Manual de usuario Pagina 13