Electrolux EOU5410BAK Manual de usuario descargar pdf (Pagina 17)

Removing the door and the glass panels

A

A

1.

Open the oven door as far as it goes.

2.

Lift up clamping levers (A) on the two

door hinges fully.

3.

Close the oven door until the first po-

sition (angle approx. 45°).

4.

Hold the oven door with one hand on

each side and pull it away from the

oven at an up angle.

5.

Put the door with the outer side down

on a soft cloth on a stable surface.

This is to prevent scratches.

B

6.

Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

7.

Pull the door trim to the front to re-

move it.

8.

Hold the door glass panels on their

top edge one by one and pull them

upwards out of the guide

9.

Clean the glass panel with water and

soap. Dry the glass panel carefully.

Installing the door and the glass

panels

When the cleaning is completed, install

the glass panels and the oven door. Do

the above steps in the opposite se-

quence. Install the smaller panel first, then

the larger.

8.4 Oven lamp

WARNING!

There is a danger of electrical

shock!

Before you change the oven lamp:

• Switch off the oven.

• Remove the fuses in the fuse box or

switch off the circuit breaker.

Put a cloth on the bottom of the

oven for protection of the oven

light and glass cover.

Replacing the oven lamp

1.

You can find the lamp glass cover at

the back of the cavity.

Turn the lamp glass cover counter-

clockwise to remove it.

2.

Clean the glass cover.

3.

Replace the oven lamp with applica-

ble 300°C heat-resistant oven lamp.

Use the same oven lamp type.

4.

Install the glass cover.

ENGLISH 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios