Electrolux EXM09HV1WI Manual de usuario descargar pdf (Pagina 7)

RemoteControl

tips and information

• When changing batteries, do not use old or

varied ones, otherwise, it may cause problems

with the remote control.

• If the remote control is not used for a long time,

remove the batteries as old batteries may leak

or corrode and damage the remote control.

• The battery life during normal use is about six

months.

• If the remote control does not operate normally,

pleaseremoveandretthebatteries.If

abnormal operation continues, replace with new

batteries.

8m

• The air conditioner will not operate if curtains,

doors or other materials block the signals from

the remote control to the indoor unit.

• Prevent any liquid from falling into the remote

control. Do not expose the remote control to

direct sunlight or heat.

• If the infrared signal receiver on the indoor

unit is exposed to direct sunlight, the air

conditioner may not function properly. Use

curtains to prevent the sunlight from falling on

the receiver.

• If other electrical appliances react to the

remote control, either move these appliances

or consult your local dealer.

IndoorUnitDisplay

• Keep the remote control where its signal can reach

the receiver of the indoor unit (a maximum distance

of 8m is allowed).

• When you select the timer operation, the remote

control automatically transmits a signal to the

indoorunitatthespeciedtime.

• If you keep the remote control in a position that

hinders proper signal transmission, a time lag of up

to 15 minutes may occur.

• When the remote control sends out a signal, the

symbol

will blink for about 1 second on the

display. The indoor unit will acknowledge the signal

with a beep when it receives an effective signal.

HeatingModeindicator

It lights when the heating function is activated

CoolingModeindicator

It lights when the cooling function is activated

PowerON/OFFindicator

It lights when the appliance is running or at

standby mode

Dehumidifyindicator

Itlightswhenthedehumidicationfunctionis

activated

Temperatureindicator

Displays the temperature setting when the Air

Conditioner is in operation

Signalreceiver

caution

HowtousetheRemoteControl

• Point the remote control to the signal receiver of

indoor unit.

• Make sure there is no obstacle that may interfere

with the signal.

Locationoftheremotecontrol

Batteryinstallation/replacement

• Slide the battery compartment cover off and

insert two new alkaline dry batteries

(2x AAA1.5Volt). Make sure that the polarity of

(+) or (-) is installed correctly.

• Slide the battery compartment cover back on

RemoteControl

tips and information

• When changing batteries, do not use old

or varied ones, otherwise, it may cause

problems with the remote control.

• If the remote control is not used for a long

time, remove the batteries as old batteries

may leak or corrode and damage the remote

control.

• The battery life during normal use is about six

months.

• If the remote control does not operate

normally,pleaseremoveandretthe

batteries. If abnormal operation continues,

replace with new batteries.

8m

• Keep the remote control where its signal

can reach the receiver of the indoor unit (a

maximum distance of 8m is allowed).

• When you select the timer operation, the

remote control automatically transmits a signal

totheindoorunitatthespeciedtime.

• The air conditioner will not operate if curtains,

doors or other materials block the signals from

the remote control to the indoor unit.

• Prevent any liquid from falling into the remote

control. Do not expose the remote control to

direct sunlight or heat.

• If the infrared signal receiver on the indoor

unit is exposed to direct sunlight, the air

conditioner may not function properly. Use

curtains to prevent the sunlight from falling on

the receiver.

• If other electrical appliances react to the

remote control, either move these appliances

or consult your local dealer.

IndoorUnitDisplay

Signal

receiver

• If you keep the remote control in a position that

hinders proper signal transmission, a time lag of

up to 15 minutes may occur.

• When the remote control sends out a signal, the

symbol

will blink for about 1 second on the

display. The indoor unit will acknowledge the

signal with a beep when it receives an effective

signal.

IFeelindicator

It lights when I Feel function is activated.

Turboindicator

Illuminates during Turbo operation.

Eco(Economy)indicator

Illuminates when ECO function is in operation.

Temperatureindicator

Displays the temperature settings when the air

conditioner is in operation.

Timerindicator

The indicator illuminates when Timer is set ON

and/or OFF.

Swingindicator

It lights when the Swing function is activated.

caution

HowtousetheRemoteControl

• Point the remote control to the signal receiver of

indoor unit.

• Make sure there is no obstacle that may interfere

with the signal.

Locationoftheremotecontrol

Batteryinstallation/replacement

• Slide the battery compartment cover off and

insert two new alkaline dry batteries

(2x AAA1.5Volt). Make sure that the polarity of

(+) or (-) is installed correctly.

• Slide the battery compartment cover back on

Light

Turbo

Timer-On

Temp

Timer-Off

Swing

I feel

Eco

Fan

Clock

Mode

1 2 3 4 5 6 7 8 9 10 11 12 ... 83 84

Comentarios a estos manuales

Sin comentarios

Electrolux EXM09HV1WI Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Electrolux EXM09HV1WI