Electrolux EHT6415K Manual de usuario descargar pdf (Pagina 17)

• This appliance is supplied with a mains

cable. It has to be supply with a correct

plug, able to support the load marked on

the rating plate. The plug has to be fitted

in a correct socket.

• Any electrical component must be instal-

led or replaced by the Service Force

Centre technician or qualified service per-

sonnel.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to the

mains plug after installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains

plug.

• Connect the appliance to the mains with

a device that lets to disconnect the appli-

ance from the mains at all poles with a

contact opening width of minimum 3

mm, eg. automatic line protecting cut-

out, earth leakage trips or fuse.

• None of a parts of the connection cable

can not get a temperature 90°C. The

blue neutral cable must be connected to

the terminal block label with "N". The

brown (or black) phase cable (fitted in the

terminal block contact marked with "L")

must always be connected to the live

phase.

REPLACEMENT OF THE CONNECTION

CABLE

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make

sure that the cable section is applicable to

the voltage and the working temperature.

The yellow/green earth wire must be ap-

proximately 2 cm longer than the brown (or

black) phase wire.

BUILDING IN

min. 600 mm

min. 55 mm

min. 650 mm

550 mm

470 mm

min. 450 mm

30 mm

A

A

B

A) supplied seal

B) supplied brackets

POSSIBILITIES FOR INSERTION

Kitchen unit with door

The panel installed below the hob must be

easy to remove and let an easy access in

case a technical assistance intervention is

necessary.

electrolux 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Comentarios a estos manuales

Sin comentarios