
6.1 What to do if...
Problem Possible cause Remedy
You cannot activate
the appliance.
The appliance is not connec‐
ted to an electrical supply or it
is connected incorrectly.
Check if the appliance is cor‐
rectly connected to the electri‐
cal supply.
You cannot activate
the appliance.
The fuse is blown. Make sure that the fuse is the
cause of the malfunction. If
the fuse is blown again and
again, contact a qualified elec‐
trician.
6.2 Before the installation
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate.
Make sure, you operated the appliance
correctly. If not the servicing by a service
technician or dealer will not be free of
charge, also during the warranty period.
The instructions about the Service
Centre and conditions of guarantee are
at the end of this manual or in the
guarantee booklet.
7. INSTALLATION
WARNING!
Refer to Safety chapters.
7.1 Hob and control-box
connection type
This appliance has a blue 1x14 pole and
red 1x14 pole connector and can be
connected to a hob with a blue 1x14 pole
and red 1x14 pole connector.
7.2 Technical Information
Dimensions
Height 124 mm
Width 547 mm
7.3 Assembly
CAUTION!
Put the second rating plate
in the cabinet B (see the
graphic below). You must
put it in a position that is
easy to see, on a surface
free of dust and grease.
• Drill the installation holes for the
control panel in the surface of the
cabinet recess. Use the template no.
374 2706 00 (cross member). Fit the
screws F loosely with the clamp.
• If necessary, you can adjust the
height of the control panel. To do that,
remove the screws D on each side of
the control panel. Loosen the screws
E, adjust the height (only + / - 10 mm
is possible) and tighten the screws
again.
• Move the control panel into the recess
and make sure that the safety clamps
are above the angle brackets. Align
the control panel and tighten from
below.
Detail C:
ENGLISH 7
Comentarios a estos manuales