
7 ENGLISH
4.2 Location of the Remote Controller
Fig.01
Max. 10m
• Keep the remote controller where its
signal can reach the receiver of the
indoor unit (a maximum distance of
10misallowed).
• When the remote controller sends
out a signal, the symbol will blink
for about 1 second on the display.
The indoor unit will acknowledge the
signal with a beep sound when it
receives an effective signal.
4.3 Battery installation/replacement
Fig.02 • Remove the back cover from the
remote controller, exposing the
battery compartment and insert two
new alkaline dry batteries (2x AAA 1.5
Volt).Makesurethatthepolarityof(+)
or(-)isinstalledcorrectly.
• Slide the battery compartment cover
back on.
•Whenchangingbatteries,do
not use old or varied ones,
otherwise, it may cause
problems with the remote
controller.
•Iftheremotecontrollerisnot
used for a long time, remove
the batteries as old batteries
may leak or corrode and
damage the remote controller.
•Thebatterylifeduringnormal
use is about six months.
•Iftheremotecontrollerdoes
not operate normally, please
removeandretthebatteries.If
abnormal operation continues,
replace with new batteries.
Comentarios a estos manuales