Electrolux EXP09HN1W6 Manual de usuario descargar pdf (Pagina 32)

32 www.electrolux.com

6. OPERATING INSTRUCTIONS

NOTE:

The following instructions represent the

Control Panel, the same instructions can

be used for the Remote Control.

Under AUTO mode, you can not select the

an speed.

COOLING MODE:

In this mode the exhaust adaptor hose

MUST be used.

AUTO MODE:

Always have the exhaust hose

attached in this mode.

TIMER OPERATION:

FAN MODE:

In this mode there is no need to use

the exhaust hose or drainage hose.

However, if you require stale or

smokey air to be removed from the

room, hook up the duct accessories

as described in the “EXHAUSTING

HOT AIR” section.

HEATING MODE: (on some models) In

this mode the exhaust adaptor hose

MUST be used.

DRY MODE:

In this mode you do not need to use

the exhaust adaptor hose, BUT the

water collected must be discharged.

See Drainage Section.

1. Press the MODE button until the “Cool”

indicator lights.

2. Press the " " Temp buttons for

desired setting.

3. Press the FAN button for desired fan

speed.

1. Press the MODE button until the “Heat”

indicator lights.

2. Press the " " Temp buttons for the

desired heat setting.

3. Press the FAN button for desired fan

speed.

4. Connected drain hose. See drainage

section.

1. Press the MODE button until the “Dry”

indicator lights.

2. The fan will run at low speed and the

display will show the room temperature.

3. Keep doors & windows closed for best

effect.

1. Press the MODE button until the “Fan”

indicator lights.

2. Press the FAN button to choose the

desired fan speed.

3. The fan will run at the selected speed

and the display will show the room

temperature.

When you set the air conditioner in AUTO

mode, it will automatically select cooling,

heating(inapplicable for cooling only

models), or fan only operation depending

on what temperature you have selected

and the room temperature. The air

conditioner will control room temperature

automatically round the temperature point

set by you.

You can set both delay stop and delay

start while unit is in ON position or OFF

position. When unit is in ON position, first

press TIMER button to go to delay stop

setting, then “timer off” light will illuminate,

tap or hold the UP arrow ( ) or the DOWN

arrow ( ) to change delay stop timer at

0.5 hour increments up to 10 hours, then

at 1 hour increments up to 24 hours. Then

press the TIMER button to confirm the

setting (the control will confirm the setting

automatically after 5 seconds) and go

to delay start setting. Use the same way

as above to set the delay start timing. If

you don’t need to set delay start, press

the TIMER button again to exit. After 5

seconds, the control will automatically

change the display back to previous

temperature display. If you want to check

remaining time, press the TIMER button.

The delay start operation automatically

selects mode, temperature and fan speed

the same as last operation you set. To

activate the Timer function when the unit

is in Off mode, press TIMER button to first

enter delay start and secondly enter delay

stop in the same way as above. To cancel

the timer setting, simply tap ( ) or ( )

button to change the timing to 0.0.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 199 200

Comentarios a estos manuales

Sin comentarios