
22
Installation
A
C
E
B
D
G
F
5358
7
H
Mechanical installation
• Markanddrill2holes(ø8mm/5/16")about
40 mm/1 9/16" deep (W475H-W4105H) and
ø 10 mm/3/8" and 50 mm/2" deep (W4130H-
W4300H) in the positions.
= position of feet
= drilling points for expander bolts
• Themachinemustbeliftedinitsbaseframe.
• Placethemachineoverthetwodrilledholes
on the foundation.
• Checkthatthemachineisinlevel,bothside-
to-sideandfronttoback.Adjustwiththefeet.
It is of utmost importance that the machine
level, from side to side as well as front to
rear. If the machine is not properly leveled,
it may result in out-of-balance without a
real out of balance in the drum.
• Inserttheexpansionboltssuppliedinthe
holes drilled in the floor. Fit the washers and
nuts, and tighten securely.
7
Front
in inch A B C D E F G H
W475H 19 1/2 18 1/8 4 5/16 5 1/8 14 3/4 6 11/16 1 9/16 3 15/16
W4105H 22 5/8 18 5/16 5 1/8 5 1/2 17 15/16 7 5/16 1 3/8 3 3/4
W4130H 25 19 5/16 5 5/16 6 7/8 20 1/4 7 11/16 2 3/8 4 5/16
W4180H 28 1/8 21 7/16 4 15/16 8 1/16 23 7/16 7 5/16 2 3/8 4 1/2
W4240H 31 1/8 24 3/16 4 1/2 7 1/16 26 3/8 6 7/8 2 3/8 4 1/2
W4300H 31 1/8 29 5/8 2 3/8 7 1/16 26 3/8 6 7/8 2 3/8 2 15/16
in mm A B C D E F G H
W475H 495 460 110 130 375 170 40 100
W4105H 575 465 130 140 455 185 35 95
W4130H 635 490 135 175 515 195 60 110
W4180H 715 545 125 205 595 185 60 115
W4240H 790 615 115 180 670 175 60 115
W4300H 790 755 60 180 670 175 60 75
Comentarios a estos manuales