Electrolux CONTROLBOX 24/7 Manual de usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 204
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
16
Certain mobile operators remove the country code from incoming texts, which can cause a problem if
ControlBox24/7 has to be controlled from a country other than where it is placed. A problem can arise sending back
the confirmation message (only applies if the STEL commando is deactivated). If the problem does occur, you can
use the following command to work around it:
NACO 0&<XXXX> Example: NACO 0&0046
0 = The numbers to be replaced by the country code (usually a zero)
XXXX = Country code where the mobile sending the command is located.
The example above enters the country code when the command text message was sent from Sweden and the
ControlBox24/7 is in another country. I.e.: it is the mobile which sends the text message which determines which
country code will be stated.
To remove the country code setting stated, send the following text message to ControlBox24/7;
NACO &
NB! Only state the country code if you find problems with receiving the confirmation message from
ControlBox24/7.
Enter country code
OTHER SETTINGS
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 203 204

Comentarios a estos manuales

Sin comentarios