Electrolux EBPL60SP Manual de usuario descargar pdf (Pagina 43)

Spots or discolouration of

the catalytic surface have no

effect on catalytic properties.

During the catalytic cleaning the oven

lamp is off.

1. Select the function: Catalysis in the

menu: Cleaning.

The display shows the time of day and

the duration of the cleaning procedure (1

hour). You cannot change the duration,

but you can delay the start of the

cleaning procedure with the function: Set

End Time.

An acoustic signal sounds after the time

ends. The appliance deactivates.

2. Touch a sensor field or open the

oven door to stop the signal.

3. Wipe the bottom of the appliance

with a soft and moist sponge.

12.4 Removing and installing

the door

You can remove the door to clean it.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A)

on the two door hinges.

A

A

3. Close the door until it is at an angle

of approximately 45°.

45°

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface.

This is to prevent scratches.

6. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, install

the door. Do the above steps in the

opposite sequence.

12.5 Replacing the lamp

Put a cloth on the bottom of the interior

of the appliance. It prevents damage to

the lamp glass cover and the cavity.

WARNING!

Danger of electrocution!

Disconnect the fuse before

you replace the lamp.

The lamp and the lamp glass

cover can be hot.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box

or deactivate the circuit breaker.

The top lamp

1. Turn the lamp glass cover

counterclockwise to remove it.

ENGLISH 43

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

Comentarios a estos manuales

Sin comentarios