Electrolux EDC5330 Manual de usuario descargar pdf (Pagina 11)

ENGLISH

Operating sequence

Before using your tumble dryer for the first time, we

recommend to place a few damp cloths inside the

appliance and dry for 30 minutes.

There may be dust inside a brand new tumble dryer.

Drying

1. Connect the appliance.

2. Open the door (see picture).

3. Load the items one at a time, shaking them out

loosely.

4. Close the door. Please check the laundry does

not get caught between the door and filter.

5. Select the drying programme or time. The lights

, and come on. The light of the

“START/PAUSE” button flashes and the

display shows the duration of the programme.

6. If required, press the low temperature button

and/or the “Buzzer OFF” button or the

“Quick drying” button

7. Select the “DELAY START” if required. The

selected delay appears on the display for 3

seconds, then the duration of the selected

programme is displayed.

8. Press the “START/PAUSE” button the

corresponding light stops flashing and drying

starts. Only the light remains lit. If you have

selected the delayed start, the machine begins

its countdown.

If the programme selector dial is turned to

another position, when the machine is running,

the buzzer will sound, the programme phase

indicator lights will flash and Err appears on the

display.

The drum turns alternately in both directions

during drying.

P1108

P1149

All drying programmes end with a 10 minute

cooling phase light is on).

You may remove the laundry after this phase.

The lights , and illuminate.

The display shows a static zero.

9. If the laundry is not removed at the end of the

cycle, the dryer performs an anti-creasing

phase (duration: 30 minutes maximum).

If you do not remove the laundry, the dryer will stop

automatically at the end of the anti-creasing phase.

Lights , and remain lit and the buzzer

sounds every 10 seconds for 2 minutes.

The light of the “START/PAUSE” button goes

off and a flashing zero appears on the display.

10. Turn the programme selector dial to “0”; all the

lights go out. The appliance is switched off.

Remove the laundry.

If you open and then close the door before

turning the selector dial to “0” all the lights

corresponding to the phases making up the

performed programme come on and the

display shows the duration of the programme.

After each use

• Clean the filters (see page 13).

• Empty the water reservoir (see page 14).

Important!

If the drying programme has to be stopped before it

reaches the end, we recommend that you turn the

programme selector dial to position and wait

until the end of this cooling phase before removing

the laundry. This will avoid a build-up of heat inside

the appliance.To do this first turn the dial to “0” and

then to and depress “START/PAUSE” button

Modifying the programme

To change a programme which is running, first

cancel it by turning the programme selector dial to

“0”. Select the new programme and press the

“START/PAUSE” button.

125992613.qxp 2005-03-07 12:45 Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 57 58

Comentarios a estos manuales

Sin comentarios

Electrolux EDC5330 Manual de usuario Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para No Electrolux EDC5330