Electrolux SC320 Manual de usuario descargar pdf (Pagina 12)

Problem Possible cause Solution

Products prevent that wa-

ter flows into the water col-

lector.

Make sure that products do

not touch the rear plate.

The temperature in

the appliance is too

low/high.

Many products are stored

at the same time.

Store less products at the

same time.

The temperature in

the refrigerator is

too high.

There is no cold air circula-

tion in the appliance.

Make sure that there is cold

air circulation in the appli-

ance.

Upper or lower

square is shown in

the temperature

Display.

An error has occurred in

measuring the tempera-

ture.

Call your service represen-

tative (the cooling system

will continue to keep food

products cold, but tempera-

ture adjustment will not be

possible).

dEMo appears on

the Display.

The appliance is in demon-

stration mode (dEMo).

Keep pressed approximate-

ly 10 sec. the OK button

since a long sound of buz-

zer is heard and the Display

shut off for a short while:

appliance start works regu-

larly.

The buzzer sounds.

The Display is red.

The door is not closed cor-

rectly.

Refer to "Door open alarm".

7.1 Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

Only service is allowed to replace the

lighting device. Contact your Service Cen-

ter .

7.2 Closing the door

1.

Clean the door gaskets.

2.

If necessary, adjust the door. Refer to

"Installation".

3.

If necessary, replace the defective

door gaskets. Contact the Service

Center.

8. INSTALLATION

WARNING!

Read the "Safety Information"

carefully for your safety and cor-

rect operation of the appliance

before installing the appliance.

8.1 Positioning

Install this appliance at a location where

the ambient temperature corresponds to

the climate class indicated on the rating

plate of the appliance:

12

www.electrolux.com

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Comentarios a estos manuales

Sin comentarios