Electrolux EKG6704X Manual de usuario descargar pdf (Pagina 24)

To adapt the appliance to a different kind of gas from the

one the appliance has been set for, follow the instructions

below in their order.

Hob burners nozzles

1. Nozzles replacement

1. Remove the pan supports.

2. Extract the caps and the wall baffles of the burners.

3. Using a socket spanner 7 unscrew and remove (Fig.

21) the nozzles replacing them with the ones

required for the kind of gas in use (see table “Burner

characteristics”).

4. Reassemble the parts following the same procedu-

re backwards.

5. Replace the rating label (placed near the gas supply

pipe) with the relevant one for the new type of gas

supply. You can find this label in the package of the

injectors supplied with the appliance.

These burners do not need any primary air regulation.

2. Adjustment of minimum level

To adjust the minimum level:

1. turn the knob to the position of minimum flame.

2. Remove the knob.

3a. When converting from natural gas to LPG, tightly

screw the by-pass screw of the cocks (Fig. 22).

3b. When converting from LPG to natural gas unscrew

about one-fourth turn by-pass screw, until a regular

small flame is reached.

Reassemble the parts following the same procedure

backards.

Check that, turning quickly the knob from the maximum

position to the minimum one, the flame does not go out.

Fig. 21

Adaptation to different kinds of gas

By-pass screw

Fig. 22

1 2 ... 19 20 21 22 23 24 25 26

Sin comentarios

Electrolux EKG6704X Manual de usuario Pagina 24