Electrolux TY58TSCN Manual de usuario descargar pdf (Pagina 60)

If you tried the above solutions and cannot

repair the problem, speak to your dealer or

the customer service. Give the data from

the rating plate, three digit letter code for

the glass ceramic (it is in the corner of the

glass surface) and an error message that

comes on.

Make sure, you operated the appliance cor-

rectly. If not the servicing by a customer

service technician or dealer will not be free

of charge, also during the warranty period.

The instructions about the customer service

and conditions of guarantee are in the guar-

antee booklet.

INSTALLATION

Warning! Refer to the Safety chapters.

Before the installation

Before the installation of the appliance, re-

cord the information below from the rating

plate. The rating plate is on the bottom of

the appliance casing.

• Model ...........................

• PNC .............................

• Serial number ....................

Warning! During installation in

combustible matter, NIN SEV 1000 and

fire protection guidelines and

regulations of the Association of

Cantonal Fire Insurance shall be strictly

adhered to.

BUILT-IN APPLIANCES

• Only use the built-in appliances after you

assemble the appliance into correct built-

in units and work surfaces that align to

the standards.

CONNECTION CABLE

• The appliance is supplied with the con-

nection cable.

• Replace the damaged mains cable with a

special cable (type H05VV-F or higher).

Speak to your local Service Centre.

ELECTRICAL CONNECTION

• Install the appliance with a socket supply

line. If there is no socket supply line, the

fixed home electrical system must include

an isolating device with at least a 3 mm-

contact separation to enable a simultane-

ous and all-pole cut off from the mains

(according to NIN SEV 1000).

TO ATTACH THE SEAL.

• If installing proud of the work surface, use

the sealing tape with dimensions 12x2

mm.

• Clean the worktop in the area of the cut

out section.

• Cut the one-sided self-adhesive sealing

tape supplied into four parts according to

the edge length of the cut-out and stick

to the worktop along the edge of the cut-

out. In doing so, the sealing tape should

protrude by approx. 3 mm over the edge

of the appliance on all sides.

• Do not stretch the sealing tapes when

sticking. Do not stick the ends on top of

each other, these should be pushed

against each other.

• After fitting the Teppan Yaki (using the

provided fitting material), the overlaying

sealing tape must be cut away on all

sides using a sharp knife. Take care not

to damage the worktop.

TO ATTACH THE SEAL TO THE

RABBET

• Clean the rabbet in the work surface.

• Bond the seal stripe supplied on the up-

per surface of the rabbet along the edges

of the cut out section.

• Cut the seal stripe into four pieces in rela-

tion to the length of the edges of the rab-

bet.

• For the four corners of the rabbet the

ends of the seal stripes must be cut into

mitres. Do not bond the ends over one

another.

• Bond the seal stripe flush into the corner

of the rabbet. Make sure that no silicon

compound can get below the appliance

when grouting.

60 electrolux

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 66 67 68

Comentarios a estos manuales

Sin comentarios