
- 13 -
DGS-TDS-N 02.06 U. H. / A. B. © Electrolux 599 525 284 EN
5.2 Individual cooking zones do not work (partially) or work incorrectly or cannot be used
Alarm Symptom Cooking
Hob
Display
Possible Alarm
Cause
Alarm Remedying
Normal cooking
phase
Pan in the border area of the pan
detection and only works with low
power
Use different pot or this pot
on a smaller hob. See
Chapter Pot Detection
Information
Pan not detected. Check whether the pots or
pans are suitable for
induction. See Pot Detection
Information
Coil not correctly connected. Check whether the coil lines
are connected and the torque
has been adhered to.
Pan does not
heat up.
Flashing
"F“
Distance between coil and glass
ceramic too large.
Check whether the coil is
applied to the glass ceramic
and whether the glass was
pushed was pushed down
when screwing in position.
No power on all
hobs
Normal cooking
phase
Demo mode activated. See Chapter demo mode
Individual buttons
cannot be used
or cannot always
be used.
Touch Control defect. 1) See Chapter 5. Touch
Control Cooking Hobs
Information.
2) Should this not help,
replace Touch Control.
Incorrectly installed, exhaust not
possible to the front.
See chapter installation
situation.
Unsuitable pots (bottom bent) See Chapter Pot Detection
Information
Induction coil is not applied to the glass
ceramic
Check whether the glass
ceramic was pushed down
when being screwed in
position and the coil has
been correctly positioned.
Cooking hob
power too low or
not provided for a
longer duration.
Normal cooking
phase
Fan does not start. 1) When setting a cooking
phase >0, the fan runs at a
slow speed. If not, check the
fan for foreign bodies,
remove these where
appropriate.
2) If necessary, replace fan.
3) Should this not succeed,
replace power component.
"H" in display
when cooking
hob and oven
cold and
switched off.
"H“
Temperature sensor defect. Replace corresponding coil
with temperature sensor.
Also see Instructions "E4“.
Comentarios a estos manuales