Electrolux EHF8748FOK Manual de usuario descargar pdf (Pagina 14)

- 14 -

DGS-TDS-N 02.06 U. H. / A. B. © Electrolux 599 525 284 EN

5.3 Alarm message „E“

When the appliance is switched on, „E“ / „xx“ Alarm Number is displayed in the timer display.

The affected zones are subsequently displayed with an „E“ in the cooking phase display and are

thereby disabed. The other zones can still be used.

Example:

1) Error code 8 for the left board

Alarm

Symptom

Display in

the Cooking

Hob Timer

Possible Alarm

Cause

Alarm Remedying

Alarm display

in the Touch

Control.

"E2“ User interface temperature

too high

Temperature too high due to

installation, or UI defect.

"E3“ 400 VAC detected, instead

of 230VAC, on left or right

module or both

1) verify power lines connection,

on the wall

2) Should alarm still be

displayed, verify internal

connection in the hob,

3) Should alarm still be

displayed, See Chapter Testing

Power Component

"E4“ Coil temperature sensor

defect, not correctly

connected, or broken,

display in the corresponding

zone.

1) Inspecting the contacts on

the power board. Is the

connector inserted?

2) The resistance at room

temperature (25°C) amounts to

100 kOhm. If not in this range,

replace affected temperature

sensor.

3) Should above not succeed,

replace power component

concerned.

"E5“ Coil temperature sensor

defect, short, display in the

corresponding zone.

1) Inspecting the contacts on

the power board.

2) The resistance at room

temperature (25°C) amounts to

100 kOhm.If not in this range,

replace affected temperature

sensor.

3) Should above not succeed,

replace power component

concerned.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Comentarios a estos manuales

Sin comentarios

Electrolux EHF8748FOK Manual de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Electrolux EHF8748FOK