Electrolux EKG911A1OX Manual de usuario descargar pdf (Pagina 25)

In installation always use the pipe holder

and the gasket. The flexible pipe can be

applied when:

• it can not get hotter than room

temperature, higher than 30 °C,

• it is not longer than 1500 mm,

• it has no narrowing anywhere,

• it is not twisted or tighten,

• it does not get in touch with sharp

edges or corners,

• it's conditions can be easily checked.

When checking the flexible pipe make

sure:

• it does not show cracks, cuts, marks

of burnings on the two ends and on its

full length,

• the material is not hardened, but

shows its correct elasticity,

• the fastening clamps are not rusted,

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING!

When installation is

complete, make sure that

the seal of each pipe fitting

does not leak. To check the

seal use a soap solution, not

a flame.

The gas supply ramp is on the rear side

of the control panel.

WARNING!

Before you connect the gas,

disconnect the appliance

from the electricity supply or

switch off the fuse in the

fuse box. Close the primary

valve of the gas supply.

14.8 Adjusting the minimum

gas level on the hob burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the hob. If there

is no access to the bypass screw

dismount the control panel before

adjustment start.

3. With a thin and flat screwdriver adjust

the bypass screw A.

The model determines the position of

the bypass screw A.

A

A

14.9 Adjusting the minimum

gas level on the oven burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the oven

functions. If there is no access to the

bypass screw dismount the control

panel before adjustment start.

3. With a thin and flat screwdriver adjust

the bypass screw A.

The model determines the position of

the bypass screw A.

A

14.10 Levelling

CAUTION!

Remove all the accessories

from the oven.

1. Open the lid of the appliance and

disassemble it.

2. Disassemble the pan supports and

all the burner assemblies.

ENGLISH 25

1 2 ... 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios