Electrolux EKI6761AEW Manual de usuario descargar pdf (Pagina 34)

13.3 Levelling of the appliance

Use small feet on the bottom of appliance

to set the appliance top surface level with

other surfaces.

13.4 Anti-tilt protection

Adjust the appliance to the correct height

and put it in the correct area before you

attach the anti-tilt protection.

CAUTION!

Install the anti-tilt protection

to prevent the appliance from

falling under incorrect loads.

The anti-tilt protection only

works when the appliance is

put in a correct area.

The anti-tilt protection has two parts (A +

B). You can find the anti-tilt protection (B)

on the right or left side of the rear wall of

the appliance.

B

1. Install the anti-tilt protection (A) on the

wall.

Make sure that the wall is made of a

solid material. If not, you need to

make the wall sufficiently strong to

hold the weight.

Make sure that the surface behind the

appliance is smooth.

2. Put the appliance in the middle of the

space between the cupboards.

If the space is larger than the width of

the appliance, you must adjust the

side measurement.

3. Install the anti-tilt protection (A)

approximately 77 mm below the top

surface of the appliance and 50 mm

from the left or right side of the

appliance into the circular hole on the

bracket. Screw it into the wall.

50 mm

77 mm

A

4. Check that the anti-tilt protection (A)

fits minimum 20 mm into the hole in

the rear wall of the appliance (B) when

you push the appliance.

13.5 Electrical installation

WARNING!

The manufacturer is not

responsible if you do not

follow the safety precautions

from Safety chapters.

This appliance is supplied without a main

plug or a main cable.

13.6 Covering terminal board

• The recommended cross-section area

is six square millimetres (6 mm²).

• When you refit the mains terminal

cover, make sure that the lower tabs

are located inside the bottom edge of

www.electrolux.com34

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

Comentarios a estos manuales

Sin comentarios