Electrolux EKK61500OW Manual de usuario descargar pdf (Pagina 25)

• the material is not hardened, but

shows its correct elasticity,

• the fastening clamps are not rusted,

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING!

When installation is

complete, make sure that

the seal of each pipe fitting

does not leak. To check the

seal use a soap solution, not

a flame.

The gas supply ramp is on the rear side

of the control panel.

WARNING!

Before you connect the gas,

disconnect the appliance

from the electricity supply or

switch off the fuse in the

fuse box. Close the primary

valve of the gas supply.

14.9 Adjustment to different

types of gas

Let only an authorized

person do the adjustment to

different types of gas.

If the appliance is set for

natural gas you can change

it to liquid gas, with the

correct injectors.

The gas rate is adjusted to

suit.

WARNING!

Before you replace the

injectors, make sure that the

gas knobs are in the Off

position. Disconnect the

appliance from the electrical

supply. Let the appliance

cool down. There is a risk of

injury.

The appliance is set to

default gas. To change the

setting always use the

gasket sealing.

A B C

DE

A. Gas connection point (only one point

is applicable for the appliance)

B. Gasket

C. Adjustable connection

D. Natural Gas pipe holder

E. LPG pipe holder

14.10 Hob injectors

replacement

Replace the injectors when you change

the gas type.

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. Remove the injectors with a socket

spanner 7.

4. Replace injectors with the ones

necessary for the type of gas you

use.

5. Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply.

You can find this plate in

the bag supplied with the

appliance.

ENGLISH 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Comentarios a estos manuales

Sin comentarios