
Problem Possible cause Remedy
There is no signal when you
touch the panel sensor fields.
The signals are deactivated. Activate the signals. Refer to
“OffSound control”.
comes on.
The Automatic Switch Off op-
erates.
Deactivate the appliance and
activate it again.
comes on.
The Child Safety Device oper-
ates.
Refer to the chapter “Daily Use”.
comes on.
No cookware is on the cook-
ing zone.
Put cookware on the cooking
zone.
The cookware is incorrect. Use the correct cookware.
The diameter of the bottom of
the cookware is too small for
the cooking zone.
Move cookware to a smaller
cooking zone.
and a number come on.
There is an error in the appli-
ance.
Disconnect the appliance from
the electrical supply for some
time. Disconnect the fuse from
the electrical system of the
house. Connect it again. If
comes on again, speak to the
service centre.
comes on.
There is an error in the appli-
ance because a cookware
boils dry. The overheating pro-
tection for the cooking zones
and the Automatic Switch Off
operate.
Deactivate the appliance. Re-
move the hot cookware. After,
approximately 30 seconds, acti-
vate the cooking zone again. If
the cookware was the problem,
the error message goes out of
the display, but the residual
heat indicator can stay. Let the
cookware become sufficiently
cool and refer to “Cookware for
the induction cooking zone” to
see if your cookware is compat-
ible with the appliance.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the Customer Care Department. Give the
data from the rating plate, three-digit-letter
code for the glass ceramic (it is in the cor-
ner of the cooking surface) and an error
message that comes on.
If you operated the appliance incorrectly,
the servicing by a customer service techni-
cian or dealer will not be free of charge,
even during the warranty period. The in-
structions about the customer service and
conditions of guarantee are in the guaran-
tee booklet.
INSTALLATION
Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Warning! During installation in
combustible matter, NIN SEV 1000 and
fire protection guidelines and
regulations of the Association of
Cantonal Fire Insurance shall be strictly
adhered to.
BUILT-IN APPLIANCES
• Only use the built-in appliances after you
assemble the appliance into correct built-
12 electrolux
Comentarios a estos manuales