Electrolux WOK38TSIO Manual de usuario descargar pdf (Pagina 13)

in units and work surfaces that align to

the standards.

CONNECTION CABLE

• The appliance is supplied with the con-

nection cable.

• Replace the damaged mains cable with a

special cable (type H05VV-F or higher).

Speak to your local Service Centre.

ELECTRICAL CONNECTION

• Install the appliance with a socket supply

line. If there is no socket supply line, the

fixed home electrical system must include

an isolating device with at least a 3 mm-

contact separation to enable a simultane-

ous and all-pole cut off from the mains

(according to NIN SEV 1000).

TO ATTACH THE SEAL.

• Clean the worktop in the area of the cut

out section.

• Bond the seal stripe supplied on the low-

er edge of the appliance along the outer

edge of the glass ceramic. Do not extend

it. Let stay the cut ends in the middle of

one side. When, you cut it to length (add

some mm), push the two ends together.

TO ATTACH THE SEAL TO THE

RABBET

• Clean the rabbet in the work surface.

• Bond the seal stripe supplied on the up-

per surface of the rabbet along the edges

of the cut out section.

• Cut the seal stripe into four pieces in rela-

tion to the length of the edges of the rab-

bet.

• For the four corners of the rabbet the

ends of the seal stripes must be cut into

mitres. Do not bond the ends over one

another.

• Bond the seal stripe flush into the corner

of the rabbet. Make sure that no silicon

compound can get below the appliance

when grouting.

ASSEMBLY

min.

50mm

min.

500mm

min.

2mm

360

+1

mm

490

+1

mm

R 5mm

55mm

electrolux 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios