Electrolux EQBH60AS Manual de usuario descargar pdf (Pagina 17)

electrolux integrated bbq 600/300mm gas requirements & ﬁtting 17

Gas requirements

Natural Gas requirements

• The enclosure must be constructed so that access

can be gained to the Natural Gas regulator at all times.

• For Natural Gas the gas supply is required to be

connected to 1.2m ﬂexible hose supplied and therefore

must be located within this distance.

• The exible hose has a quick connect gas coupling.

The corresponding mating ﬁtting will be required at

the gas supply end.

• For pipe sizing requirements for supply pipe refer

to AS5601.

Universal LPG Requirements

warning

• If an LPG bottle is to be stored in the enclosure under

the barbecue unit, it must be isolated from the barbecue

unit with a non-combustible panel.

The enclosure must comply with the requirements

of AS5601.

• AS5601 ventilation requirements for cylinder storage are:

Where of sheet metal or similar impervious construction

there shall be ventilation openings at the top and bottom

of the enclosure or recess, each opening providing a

free area of at least 200cm2 for every cylinder enclosed.

• For ULPG installations having enclosed cabinetry below

the separation panel that does not contain a gas bottle,

low level venting must be installed. This is to allow the

gas which is heavier than air escape from the enclosure

in the situation where there may be a leak. A minimum

opening of 200cm

is required.

Setting up the barbecue

Setting up the barbecue in mounting enclosure

• A match holder with attached chain has been included

with the instruction manual. This is provided for manual

ignition in the event the automatic ignition does not work.

The free end of chain is required to be permanently ﬁxed

to the installation in a location that enables the match

holder to reach each burner (refer to page 18 for manual

lighting instructions).

• After the enclosure has been constructed as described

on page 13, position the assembled barbecue into the

cut-out hole.

• Check that the barbecue is level and is rmly supported.

• Connect to gas supply (Universal LPG or Natural Gas)

and leak test.

• For tment of the slimline lid or roasting hood (see right).

Fitting the slimline lid or roasting hood

Fitting of slimline lid

• Unpack the slimline lid.

• Remove side screws from barbecue trim surround

using a philips head screw driver.

• Cooking plates should be removed in order to attach

hinge bracket.

• Fit brackets to trim surround with the same screws.

• Fit lid to brackets.

Fitting of roasting hood

• Unpack the roasting hood.

• Remove side and rear screws from barbecue trim

surround using a philips head screw driver.

• Cooking plates should be removed in order to attach

hinge bracket.

warning

Due to the size of the roasting hood, it is recommended

that two people place the roasting hood into position.

• When tting roasting hood assembly, take particular

care to avoid scratching of the external trim.

• Once in position, x hood assembly to trim surround

with same screws.

INTBBQ600/300_Jun11.indd 17 30/06/11 11:53 AM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Electrolux EQBH60AS Manual de usuario Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para No Electrolux EQBH60AS