Electrolux ROB2211AOX Manual de usuario descargar pdf (Pagina 21)

When the cleaning is completed, install

the glass panel and the oven door.

The screen-printing zone must face the

inner side of the door. Make sure that

after the installation the surface of the

glass panel frame on the screen-printing

zones is not rough when you touch it.

When installed correctly the door trim

clicks.

Make sure that you install the internal

glass panel in the seats correctly.

A

10.7 Replacing the lamp

WARNING!

Risk of electric shock.

The lamp can be hot.

1. Turn off the oven.

Wait until the oven is cooled down.

2. Disconnect the oven from the mains.

3. Put a cloth on the bottom of the

cavity.

CAUTION!

Always hold the halogen

lamp with a cloth to prevent

grease residue from burning

on the lamp.

The back lamp

1. Turn the lamp glass cover to remove

it.

2. Clean the glass cover.

3. Replace the lamp with a suitable 300

°C heat-resistant lamp.

4. Install the glass cover.

11. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

11.1 What to do if...

Problem Possible cause Remedy

The oven does not heat

up.

The oven is deactivated. Activate the oven.

The oven does not heat

up.

The Minute Minder + End

of Cooking programmer is

not set.

Set the Minute Minder +

End of Cooking program‐

mer. Refer to the chapter

"Clock functions".

The oven does not heat

up.

The fuse is blown. Make sure that the fuse is

the cause of the malfunc‐

tion. If the fuse is blown

again and again, contact a

qualified electrician.

The lamp does not oper‐

ate.

The lamp is defective. Replace the lamp.

Steam and condensation

settle on the food and in

the cavity of the oven.

You left the dish in the

oven for too long.

Do not leave the dishes in

the oven for longer than 15

- 20 minutes after the

cooking process ends.

ENGLISH 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

Comentarios a estos manuales

Sin comentarios