
Install the shelf supports in the opposite
sequence.
CAUTION!
Make sure that the longer
fixing wire is in the front. The
ends of the two wires must
point to the rear. Incorrect
installation can cause
damage to the enamel.
11.5 Removing the oven door
To make the cleaning easier, remove the
door.
1. Open the oven door about one-third
of the way.
2. Hold the sides of the oven door with
both hands and pull the door off the
oven.
CAUTION!
Put the oven door with the
outer side down on a soft
material and level surface to
prevent from scratches.
To install the door follow the procedure in
reverse. Press down until the assembly
spring clicks into the position.
11.6 Removing and cleaning
the door glasses
The door glass in your
product can be different in
type and shape from the
examples you see in the
images. The number of
glasses can also be
different.
1. Hold the door trim B on the top edge
of the door at the two sides and push
inwards to release the clip seal.
2. Pull the door trim to the front to
remove it.
3. Hold the door glass panels on their
top edge one by one and pull them
upwards from the guide.
4. Clean the door glass panels.
To install panels, do the same steps in
reverse.
11.7 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
ENGLISH 35
Comentarios a estos manuales