Electrolux EKK60331 Manual de usuario descargar pdf (Pagina 29)

electrolux 29

Electrical connection

The unit is preset to work with a voltage

of single phase 230 V.

Before making the connection make sure

that:

- the energy power available in the user's

house is sufficient for the normal supply

of this appliance (see rating plate).

- the unit is correctly connected to earth

through a suitable plug and according to

the installation country Laws.

- the socket or the omnipolar switch used

for the connection must be easilv

reached with the installed appliance.

The appliance is supplied with electric

cable, therefore you will have to fit it with a

standard plug, suitable for the total electric

load shown on the rating plate. The plug is

to be inserted into a suitable wall socket.

If you wish to directly connect to the

mains, you have to interpose an omnipolar

switch with a minimum opening between

contacts of 3 mm, between the unit and the

mains, complying with the existing

regulations. The brown live wire (originating

from the clamp of the appliance junction box)

must always be connected to the phase of

the mains supply. In any case, the supply

cord must be positioned in such a way as it

doesn't reach in any point a temperature

higher by 50°C than the room temperature.

Replacement of the electric cable

Should the supply cord need to be

replaced, use only the following cable types:

H07 RN-F, H05 RN-F, H05 RR-F, H05 VV-

F, H05 V2V2-F (T90), H05 BB-F. It is

necessary that the yellow/green earth wire is

about 2 cm longer than the live and neutral

ones (Fig. 18). After the connection, test the

heating elements for about 3 minutes to

ensure that they are working correctly.

The manufacturer refuses any

responsability in cases where normal

safety measures are not observed.

Fig. 18

Ground (yellow - green)

Neutral

wire

Phase

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

Comentarios a estos manuales

Sin comentarios