Electrolux EQG4120BOG Manual de usuario descargar pdf (Pagina 11)

5.

Replace the rating label (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this label in the package of the injec-

tors supplied with the appliance.

8.3 Adjustment of minimum level

To adjust the minimum level of the

burners:

1.

Light the burner.

2.

Turn the knob on the minimum posi-

tion.

3.

Remove the knob.

4.

With a thin screwdriver, adjust the by-

pass screw position.

A

A)

The by-pass screw

• If you change from natural gas 20 mbar

to liquid gas, fully tighten the adjust-

ment screw in.

• If you change from liquid gas to natural

gas 20 mbar, undo the by-pass screw

approximately 1/4 of a turn.

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

8.4 Electrical connection

• Ground the appliance according to

safety precautions.

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable.

• Any electrical component must be in-

stalled or replaced by the Service Force

Centre technician or qualified service

personnel.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to

the mains plug after installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• The appliance must not be connected

with an extansion cable, an adapter or

a multiple connection (risk of fire).

Check that the ground connection is in

conformity with the standard and regu-

lations force.

• The power cable must be placed in

such a way that it does not touch any

hot part.

• Connect the appliance to the mains

with a device that lets to disconnect the

appliance from the mains at all poles

with a contact opening width of mini-

mum 3 mm, eg. automatic line protect-

ing cut-out, earth leakage trips or fuse.

• None of a parts of the connection cable

can not get a temperature 90°C.

8.5 Replacement of the

connection cable

In order to replace the connection cable

speak your local Service Force Centre!

To replace the connection cable use only

H05BB-F Tmax 90°C (or higher) type.

Make sure that the cable section is appli-

cable to the power and the working tem-

perature. The yellow/green earth wire

must be approximately 2 cm longer than

all phase wires.

ENGLISH 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios