Electrolux Electric Slide-In Range Guía para resolver problemas descargar pdf (Pagina 39)

3-17

Section 3 Electronic Controls Guide

Surface cooking settings

Use the chart to determine the correct setting for the

type of food you are preparing.

Note: Thesizeandtypeofcookwareusedwillinuence

the setting needed for best cooking results.

Recommended Setting for Surface Element

Setting Type of Cooking

HIGH(HI) Start most foods; bring water to a boil

and pan broiling.

MEDIUM HIGH

(8-10)

Continue a rapid boil; frying, deep fat

frying.

MEDIUM(6) Maintain a slow boil; thicken sauces

and gravies; steaming vegetables.

MEDIUM LOW

(2-4)

Keep foods cooking; poaching and

stewing.

LOW(LO) Keep warm, melting and simmering.



NOTE

Radiant elements have a limiter that allows the element

to cycle on and off, even at the HI setting. This helps to

prevent damage to the ceramic smooth top. Cycling at

the HI setting is normal and can occur if the cookware

is too small for the radiant element or if the cookware

bottomisnotat.

The electronic surface element control

(ESEC) (Models B & C only)

TheElectronicSurfaceElementControl(ESEC)feature

includes digital display windows. The ESEC feature

provides a numeric digital setting for the radiant surface

element positions on the cooktop. These settings work

the same way as normal knob setting indicators work

except the settings are displayed in digital windows.

The available ESEC display settings

The ESEC control provides various heat levels from Hi

(Figure2)toLo(Figure5)andOFF(Figure1).The

settings between 3.0 and 9.5 increase or decrease in

incrementsof.5(1/2).Thesettingsbetween1.2 and

3.0 are Simmer settings which decrease or increase in

incrementsof.2(1/5)toLo(Figure5;lowestSimmer

setting)formoreprecisesettingsatlowerheatlevels.Use

the Recommended Surface Setting Chart to determine the

correct setting for the kind of food you are preparing.

ESEC power failure indicator message (PF)

Whentherangeisrstpluggedinorwhenthepower

supply to the range has been interrupted, the ESEC

control will display the message "PF"(PowerFailure;

Figure6).Afterafewsecondsthe"PF" message will

disappear from the display.

ESEC hot element indicator message (HE)

After using any of the single or dual radiant element

positions the cooktop will become very hot. Even after

turning the control knob to OFF, the cooktop will remain

hot for some time. The ESEC control monitors the

temperature of the cooktop and displays the message

“HE”(hotelement)warningwhenthecooktopisstilltoo

hottotouch(Figure4).IftheHE message appears in the

window, the control can still be turned ON again for use.

ESEC error indicator message (Er)

Anerrormessagewillbedisplayed(glowing“Er”)at

powerup(orafterapowerfailure)ifANYofthesurface

controlknobswereleftintheONpositions(Figure7).

If a power failure should occur, be sure to set all of the

surface control knobs to the OFF position. This will reset

the surface controls.

Once the surface controls have been set to the OFF

positions, the surface controls should return to normal

operation. If the surface controls do not function and

the “Er” message remains in any display after following

these procedures, contact your authorized servicer for

assistance.

ESEC Lockout Feature ( - - )

The ESEC feature will not operate during a Self-Clean

cycle or when the Lockout feature is active. Whenever

the Lockout feature is active, “ - - “ will appear in any

ESECdigitaldisplaywindows(SeeFigure8)toshowthat

all surface elements can not be activated.

Figure 2

Figure 5

Figure 3

Figure 6

Figure 7

Figure 8

Figure 1

Figure 4

Fig. 2

Control knobs shown are typical only.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 92 93

Comentarios a estos manuales

Sin comentarios

Electrolux Electric Slide-In Range Guía para resolver problemas Pagina 39

Comentarios a estos manuales

Relacionado con productos y manuales para Hornos Electrolux Electric Slide-In Range