Electrolux ER8817C Manual de usuario descargar pdf (Pagina 13)

13 Electrolux 818 14 51--01/7

Installing the cabinet

To obtain the best performance from the cabinet,

ensure :

· the cabinet is placed in a dry, cool place and

is not exposed to direct sunlight.

· the cabinet is not placed close to a source of

heat, e.g. a cooker or dishwasher.

· the room in which the cabinet is placed

has a temperature of +16Cto+32C.

· the cabinet is level. The cabinet should not lean

against any wall. If necessary adjust the

feet using the adjustment spanner supplied.

· there is good air circulation around the cabinet

and that the air channels below and behind

the cabinet are not blocked. The ventilation

space above the cabinet must be at least 200 cm2.

The ventilation space can either be

a) directly above the cabinet, or

b) behind and above the top cupboard. In this case,

the space behind the cupboard must be at least

50 mm deep.

Check that the drain hose at the rear of the cabinet

discharges into the drip tray.

If the cabinet is placed in a corner and the side with

the hinges faces the wall, the distance between the

wall and the cabinet must be at least 10 mm to allow

the door to open enough so that the shelves can be

removed.

50mm

Electrical connection

Any electrical work required to install this

appliance should be carried out by a

qualified electrician or competent person.

This appliance must be earthed.

The manufacturer declines any liability should

these safety measures not be observed.

Electrical Requir ements

Before switching on, make sure the electricity

supply voltage is the same as that indicated on the

appliance rating plate.

The appliance is supplied with a 13amp plug fitted.

In the event of having to change the fuse in the plug

supplied, a 13amp ASTA approved (BS1362) fuse

must be used.

Should the plug need to be replaced for any reason.

The wires in the mains lead are coloured in

accordance with the following code:

Green and yellow -Earth

Blue -Neutral

Brown -Live

The wire coloured green and yellow must be

connected to the terminal marked with the letter "E"

or by the earth symbol

or coloured green and

yellow.

The wire coloured blue must be connected to the

terminal marked "N" or coloured black

The wire coloured brown must be connected to the

terminal marked "L" or coloured red.

Upon completion there must be no cut, or stray

strands of wire present and the cord clamp must be

secure over the outer sheath.

1 2 ... 8 9 10 11 12 13 14 15

Comentarios a estos manuales

Sin comentarios

Electrolux ER8817C Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para No Electrolux ER8817C