Electrolux SC380CN Manual de usuario descargar pdf (Pagina 10)

Problem Possible cause Solution

Audible or visual alarm is

on.

The cabinet has been re‐

cently switched on or the

temperature is still too

high.

Refer to "Door Open

Alarm"or "High Temperature

Alarm".

The temperature in the

appliance is too high.

Refer to "Door Open

Alarm"or "High Temperature

Alarm".

A square symbol is shown

instead of numbers on the

temperature display.

Temperature sensor prob‐

lem.

Contact the nearest Author‐

ised Service Centre (the

cooling system will continue

to keep food products cold,

but temperature adjustment

will not be possible).

The lamp does not work. The lamp is in stand-by

mode.

Close and open the door.

The lamp does not work. The lamp is defective. Contact the nearest Author‐

ised Service Centre.

The compressor operates

continually.

Temperature is set incor‐

rectly.

Refer to "Operation"/"Control

panel" chapter.

Many food products were

put in at the same time.

Wait a few hours and then

check the temperature

again.

The room temperature is

too high.

Refer to climate class chart

on the rating plate.

Food products placed in

the appliance were too

warm.

Allow food products to cool

to room temperature before

storing.

The COOLMATIC func‐

tion is switched on.

Refer to "COOLMATIC func‐

tion".

The compressor does not

start immediately after

pressing the COOLMATIC

or after changing the tem‐

perature.

This is normal, no error

has occurred.

The compressor starts after

some time.

Water flows inside the re‐

frigerator.

The water outlet is clog‐

ged.

Clean the water outlet.

Food products prevent

water from flowing into

the water collector.

Make sure that food prod‐

ucts do not touch the rear

plate.

www.electrolux.com10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios