
Problem Possible cause Solution
Water flows on the floor. The melting water outlet
is not connected to the
evaporative tray above
the compressor.
Attach the melting water out‐
let to the evaporative tray.
Temperature cannot be
set.
The FROSTMATIC or
COOLMATIC function is
switched on.
Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "FROST‐
MATIC or COOLMATIC
function".
DEMO appears on the
display.
The appliance is in dem‐
onstration mode.
Keep the OK pressed for ap‐
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
The temperature in the
appliance is too low/too
high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera‐
ture.
The food products tem‐
perature is too high.
Let the food products tem‐
perature decrease to room
temperature before storage.
Many food products were
stored at the same time.
Store less food products at
the same time.
The COOLMATIC func‐
tion is switched on.
Refer to "COOLMATIC func‐
tion".
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door was opened too fre‐
quently.
Open the door only when
necessary.
Door was not closed com‐
pletely.
Make sure the door is closed
completely.
Stored food was not
wrapped.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Door does not open easi‐
ly.
You attempted to re-open
the door immediately after
closing.
Wait a few seconds between
closing and re-opening of the
door.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
6.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
ENGLISH 11
Comentarios a estos manuales