Electrolux TY38TSCN Manual de usuario descargar pdf (Pagina 59)

ous and all-pole cut off from the mains

(according to NIN SEV 1000).

TO ATTACH THE SEAL.

• If installing proud of the work surface, use

the sealing tape with dimensions 12x2

mm.

• Clean the worktop in the area of the cut

out section.

• Cut the one-sided self-adhesive sealing

tape supplied into four parts according to

the edge length of the cut-out and stick

to the worktop along the edge of the cut-

out. In doing so, the sealing tape should

protrude by approx. 3 mm over the edge

of the appliance on all sides.

• Do not stretch the sealing tapes when

sticking. Do not stick the ends on top of

each other, these should be pushed

against each other.

• After fitting the Teppan Yaki (using the

provided fitting material), the overlaying

sealing tape must be cut away on all

sides using a sharp knife. Take care not

to damage the worktop.

TO ATTACH THE SEAL TO THE

RABBET

• Clean the rabbet in the work surface.

• Bond the seal stripe supplied on the up-

per surface of the rabbet along the edges

of the cut out section.

• Cut the seal stripe into four pieces in rela-

tion to the length of the edges of the rab-

bet.

• For the four corners of the rabbet the

ends of the seal stripes must be cut into

mitres. Do not bond the ends over one

another.

• Bond the seal stripe flush into the corner

of the rabbet. Make sure that no silicon

compound can get below the appliance

when grouting.

ASSEMBLY

min.

50mm

min.

500mm

min.

2mm

< 20 mm

min. 2 mm

A

B

A

12 mm

28 mm

38 mm

B

57 mm

41 mm

31 mm

min

30 mm

min. 500 mm

> 20 mm

min. 2 mm

A

B

A

12 mm

28 mm

38 mm

B

57 mm

41 mm

31 mm

min. 500 mm

Mounting on the top

electrolux 59

1 2 ... 54 55 56 57 58 59 60 61 62 63 64

Comentarios a estos manuales

Sin comentarios