Electrolux EOB8741AOX Manual de usuario descargar pdf (Pagina 40)

• If you have nonstick accessories, do

not clean them using aggressive

agents, sharp-edged objects or a dish-

washer. It can cause damage to the

nonstick coating.

12.1 Steam cleaning

1.

Remove the worst of the dirt manual-

ly.

2.

Put approximately 250 ml of water

and 3 tablespoons of vinegar directly

into the steam generator.

3.

Touch again and again until the

display shows

.

4.

The display shows the duration (15

minutes) and the default temperature.

Touch

to start the cleaning.

5.

An acoustic signal sounds when the

steam cleaning is completed. Touch a

sensor field to stop the signal.

6.

Clean the appliance with soft cloth.

Remove the water from the steam

generator with the sponge and rub it

dry.

Keep the door open for approxi-

mately 1 hour to let the appliance

dry fully.

You can use the End function to

delay the start of the cleaning. Re-

fer to "Setting the END".

12.2 Shelf supports

You can remove the shelf supports to

clean the side walls.

Removing the shelf supports

2

3

1

1.

Carefully pull the supports up and out

of the front catch.

2.

Lightly move the supports on the front

catch inwards.

3.

Pull the supports out of the rear

catch.

Installing the shelf supports

Install the shelf supports in the opposite

sequence.

12.3 Steam generation system

CAUTION!

Dry the steam generator after

each use. Remove the water with

the sponge.

Remove the limescale with water

and vinegar.

CAUTION!

Chemical de-scaling agents can

cause damage to the enamel. Fol-

low the instructions of the manu-

facturer.

Cleaning the water drawer and the

steam generator:

1.

Put the water and vinegar mixture

(approximately 250 ml) through the

water drawer into the steam genera-

tor. Wait for approximately 10 mi-

nutes.

2.

Remove the water and vinegar with

the sponge.

3.

Put clean water (100 - 200 ml) into

the water drawer to flush the steam

generation system.

4.

Remove the water from the steam

generator with the sponge and rub it

dry.

5.

Keep the door open to let the appli-

ance dry fully.

12.4 Lamp

WARNING!

There is a risk of electrical shock.

The lamp and the lamp glass cov-

er can be hot.

Before you change the lamp:

• Deactivate the appliance.

• Remove the fuses from the fuse box or

deactivate the circuit breaker.

40

www.electrolux.com

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Comentarios a estos manuales

Sin comentarios