Electrolux EOD67043X Manual de usuario descargar pdf (Pagina 20)

Caution! Do not attempt to clean

catalytic surfaces with oven sprays,

abrasive cleaners, soap or other

cleaning agents. This may damage the

catalytic surface.

Discolouration of the catalytic surface

has no effect on catalytic properties.

Shelf Support Rails

Removing the shelf support rails

1. Pull the front of the shelf support rail

away from the side wall.

2. Pull the rear shelf support rail away

from the side wall and remove it.

Installing the shelf support rails

Install the shelf support rails in opposite se-

quence.

The rounded ends of the shelf support

rails must point to the front!

Oven door and glass panels

To clean the oven door remove it.

Caution! Be careful when you remove

the door from the appliance. The door

is heavy!

Removing the oven door

1. Open the oven door as far as it goes.

2. Lift up clamping levers (A) on the two

door hinges fully.

A

A

3. Close the oven door until the first posi-

tion (angle approx. 45°).

45°

4. Hold of the oven door with one hand

on each side and pull it away from the

oven at an upwards angle.

Put the oven door with the outer side

down on a soft and level surface to

prevent scratches.

5. Now you can remove the inner glass

panels and clean them.

To install the door follow the procedure

in reverse.

The oven door has 2, 3 or 4 panels of

glass (depends on the model)

20 electrolux

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios