Electrolux EASX24C5ATLW Manual de usuario descargar pdf (Pagina 16)

Piping and wrapping

1. Bundle the tubing, connecting

cable, and drain hose with tape

securely, evenly as shown.

2. Because the condensed water

from rear of the indoor unit is

gathered in ponding box and is

piped out of room. Do not put

anything else in the box.

1. Connect the indoor unit first, then the outdoor unit.

2. Do not allow the piping to let out from the back of the indoor unit.

3. Be careful not to let the drain hose slack.

4. Heat insulated both of the auxiliary piping.

5. Be sure that the drain hose is located at the lowest side of the bundle.

Locating at the upper side can cause drain pan to overflow inside the unit.

6. Never intercross nor intertwist the power wire with any other wiring.

7. Run the drain hose sloped downward to drain out the condensed water

smoothly.

15 electrolux indoor unit installation

Indoor unit

Cable

de conexión

Ponding

box

Pipe room

Wrapping

belt

Drain hose

Connective

pipe

3. Piping can easily be made by lifting

the indoor unit with a cushioning

material between the indoor unit

and the wall. Get it out after finish

piping.

4. Push the lower part of the indoor unit

up on the wall, then move the

indoor unit from side to side, up and

down to check if it is hooked

securely.

Cushioning

material

how the air conditioner works electrolux 40

Time

DRY FUNCTION

Room

Temperature

Set temperature

Cooling

Fan only

DRY operation

The dry mode will automatically

select the drying operation based

on the difference between the set

temperature and the actual room

temperature.

The temperature is regulated while

dehumidifying by repeating turning

on and off of the cooling operation

or fan only. The fan speed is LOW.

1. Push the MODE button to select

DRY.

2. Push the TEMP button to set the

desired temperature from 21ºC

to 28ºC.

3. Push the ON/OFF button, the

operation lamp lights and the air

conditioner start to operate in

the DRY mode. FAN SPEED is

Low. Push the ON/OFF button

again to stop this unit operation.

Due to the difference of the set

temperature of the unit and the

actual indoor temperature, the Air

Conditioner when in DRY mode will

automatically operate many times

without running the Cold and FAN

mode.

Air flow direction adjustment

Use SWING to adjust the airflow direction up and down.

1. When swing is pressed the horizontal louver moves up and down

automatically. Press again to stop operation.

If the louver oscillates or moves in a position that could affect the cooling or

heating of the air conditioner the direction of the oscillation/movement would

alter automatically.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comentarios a estos manuales

Sin comentarios

Electrolux EASX24C5ATLW Manual de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Electrolux EASX24C5ATLW