Electrolux EASX24C5ATLW Manual de usuario descargar pdf (Pagina 17)

1. Install the outdoor unit on a rigid

base to prevent increasing noise

level and vibration.

2. Determine the air outlet direction

where the discharged air is not

blocked. In the case that the

installation place is exposed to

strong wind such as a seaside,

make sure the fan operating

properly by putting the unit

lengthwise along the wall or using

a dust or shield plates.

3. Specially in windy area, install the

unit to prevent the admission of

wind. If need suspending

installation, the installation bracket

should accord with technique

requirement in the installation

bracket diagram.

4. The installation wall should be solid

brick, concrete or the same

intensity construction, or actions to

reinforce, damping supporting

should be taken. The connection

between bracket and wall, bracket

and the air conditioner should be

firm, stable and reliable.

5. Be sure there is no obstacle which

block radiating air.

Outdoor unit installation

Strong wind

outdoor unit installation electrolux 16

39 electrolux how the air conditioner works

How the air conditioner works

Automatic operation

When the Air Conditioner is ready for use, switch on the power and the

OPERATION indicator lamp on the display panel of the indoor unit starts

flashing.

1. Use the MODE .select button to select AUTO.

2. Push the TEMP button to set the desired room temperature. The most

comfortable temperature setting are between 21ºC o to 28ºC.

3. Push the ON/OFF button to start the air conditioner. The OPERATION lamp

on the display panel of the indoor unit lights. The

operating mode is AUTO FAN SPEED is automatically set and there are no

indicators shown on the display panel of the remote controller.

4. Push the ON/OFF button again to stop the unit operation.

COLD / HEAT and FAN ONLY operation

1. If the AUTO mode is not comfortable, you may manually override the settings

by using COLD, HEAT* or FAN** ONLY modes.

2. Push the TEMP button to set the desired room temperature. When in Cold

mode, the most comfortable settings are 21ºC or above. When in HEAT

mode, the most comfortable settings are 28 C or b elow.

3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.

4. Push the ON/OFF button, the operation lamp lights and the air conditioner

start to operate as your settings. Push the ON/OFF button again to stop this

unit operation.

* Nota: Only for heating and cooling models

**Note: The FAN ONLY mode can not be used to control the temperature.

While in this mode, only steps 1,3 and 4 may be performed.

1. When you set the air conditioner in AUTO mode, it will automatically select

cooling, heating(cooling/heating models only), or fan only operation

depending on what temperature you have selected and the room

temperature.

2. The air conditioner will control room temperature automatically round the

temperature point set by you.

3. If the AUTO mode is uncomfortable, you can select desired conditions

manually.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comentarios a estos manuales

Sin comentarios

Electrolux EASX24C5ATLW Manual de usuario Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Electrolux EASX24C5ATLW