Electrolux EASX24C5ATLW Manual de usuario descargar pdf (Pagina 21)

Electrical work

1. If there is serious safety problem

about the power supply, the

technicians should refuse to install

the air conditioner and explain to

the client until the problem is

solved.

2. Power voltage should be in the

range of 90%~110%of rated

voltage.

3. The creepage protector and main

power switch with a 1.5 times

capacity of Max. Current of the unit

should be installed in power circuit.

4. Ensure the air conditioner is

grounded well.

5. According to the attached Electrical

Connection Diagram located on the

panel of the outdoor unit to connect

the wire.

6. All wiring must comply with local

and national electrical codes and be

installed by qualified and skilled

electricians.

7. An individual branch circuit and

single receptacle used only for this

air conditioner must be available.

See the following table for

suggested wire sizes and fuse

specifications:

Electric safety regulations for the initial Installation

electrical work electrolux 20

Remote control description

35 electrolux remote control description

1

2

3

5

6

TEMP :Press the button to

decrease the indoor temperature

setting.

MODE: Each time you push the

button, a mode is selected in a

sequence that goes from AUTO,

COLD, DRY, HEAT*, and FAN, as the

following figure indicates:

* Note: Only for heating models.

SWING: Push this button, the louver

would swing up and down

automatically. Push again to stop it.

SLEEP: Press this button to go into

the Energy-Saving operation mode.

Press it again to cancel. This

function is only can be used on

COLD, HEAT and AUTO mode and

maintain the most comfortable

temperature for you. While the unit

is running under SLEEP operation

mode, it would be canceled if you

press the other button.

RESET: When you press the

recessed RESET button, all current

settings are cancelled and the

control will return to the initial

settings.

AIR DIRECTION: Press this button

to change the swing angle of the

louver. The swing angle of the louver

is 6o for each press. When the

louver swing at a certain angle

which would affect the cooling and

heating effect of the air conditioner,

4

1

2

3

4

5

6

7

8

9

10

11

12

13

14

AUTO

COLD DRY HEAT* FAN

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios