
Service
Manual
Edition
Type
12. Function Sequences
12
17 9108
Page
Out-of-balance
This acts as a safeguard against excessive stress during the extraction. If
the wash is unevenly distributed in the drum, the extraction stops, the wash
is redistributed and the extraction starts again. This takes place
automatically as follows:
• Out-of-balance switch S9 (3) trips.
Immediately afterwards:
• Relay coil K53 (10) is energised and locks since K53:33-34 (4) and
K53:43-44 (6) closes.
• K53:81-82 (28) cuts power to spin contacts K9 and K10, and the
machine stops the extraction.
• K53:71-72 (16) cuts power to relay coil K3 (17) (distribution speed).
• K53:51-52 (18) cuts power to relay coil K31 (21). This closes K31:71-72
(24), energising drain valve Y1 (25) and closing the drain.
• K53:13-14 (7) closes, energising valve Y14 (9) and letting cold water into
the drum.
If the drum speed falls below about 310 rpm (220 litre models) or 550 rpm
(120 litre models):
• Speed control B31 (11) switches to position 1-2. Since K31:51-52 (12)
is closed, this energises relay K2, and the machine starts to run at wash
speed.
Once the water reaches the high level:
• Level control B1 (5) switches to position 31-33, cutting the power to relay
coil K53 (10). K53 unlocks. Valve Y14 (9) closes.
• K53:51-52 (18) closes, relay coil K31 (21) is energised when reverser
contact 3b closes (see ”Distribution speed”). Drain valve Y1 (25) is de-
energised (K31:71-72 (24) breaks) and the drain opens.
• K31:51-52 (12) cuts the power to relay K2, K31:43-44 (13) closes,
energising relay coil K3 (17). The machine switches from wash speed to
distribution speed.
• After about 30 seconds, time relay K63 contact 12-13 (30) closes. If the
water level now falls below level control B1 (29)
minimum safety level (extraction), this energises extraction relay K9 and
the extract starts again. At the same time, K9:11-12 (15) cuts the power
to relay coil K3 (17).
24
Comentarios a estos manuales