Electrolux SM 554 Manual de servicio Pagina 47

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 91
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 46
Service
Manual
9406
Description
The programmer is electronic and is made up of two circuit
boards, the control board with microprocessors and
program memory, and the relay board with relays and
interference suppression circuits. The programmer has the
following outputs and inputs:
Outputs which, via relays, control the various functions
of the machine such as water fill, drain, spin etc.
Outputs which control the information that is to appear
on the display.
Inputs that detect keystrokes from the keyboard.
Inputs that give information about the status of the
washing machine from, for example, thermostat
sensors, level detectors, out-of-balance detectors, door
lock and speed switch.
The programmer is controlled by the instructions stored in
the program memory. The memory is in the form of two
memory chips (see diagram below):
The lower chip, which contains memory information that
cannot be changed, contains instructions about
operation, service program, relay control, sensing of
inputs etc. It also contains the standard programs
supplied with the machine on delivery.
The upper memory chip stores programs created by the
customer. The content of this memory can easily be
changed by erasing unwanted programs and creating
new ones.
23. Programmer
23
P1 Display
contrast adjust-
ment (normal
adjustment:
fully clockwise
minus 1-2 mm)
Program chip
for standard
programs
Program chip
for user
programs
Level check
P4 Not to be used
factory setting only
X1 Connector for control panel
Service switch
Display
X3
X4
X7
X8
Connection for
key switch
X6X5
S1
5V
S2 S3
12V
Control
Transformator Fuses
3
1103
P3 level check adjustment,
mid-position
P2 level check adjustment, zero position
Vista de pagina 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 90 91

Comentarios a estos manuales

Sin comentarios