
Refer to "Care and cleaning"
chapter.
Clean the appliance before first use.
Put the accessories and the removable
shelf supports back to their initial
position.
4.2 Setting the time
After the first connection to the mains, all
symbols in the display are on for some
seconds. For the subsequent few
seconds the display shows the software
version.
After the software version goes off, the
display shows and "12:00". "12"
flashes.
1. Press or to set the current
hour.
2. Press
to confirm. This is
necessary only when you set the
time for the first time. Later the new
time will be saved automatically after
5 seconds.
The display shows and the set
hour. "00" flashes.
3. Press or to set the current
minutes.
4. Press
to confirm. This is
necessary only when you set the
time for the first time. Later the new
time will be saved automatically after
5 seconds.
The display shows the new time.
Changing the time
You can change the time of day only if
the oven is off.
Press again and again until the
indicator for the time of day
flashes in
the display.
To set a new time, refer to "Setting the
time".
4.3 Preheating
Preheat the empty appliance to burn off
the remaining grease.
1. Set the function and the maximum
temperature.
2. Let the appliance operate for 1 hour.
3. Set the function and the maximum
temperature.
4. Let the appliance operate for 15
minutes.
5. Set the function
and the maximum
temperature.
6. Let the appliance operate for 15
minutes.
Accessories can become hotter than
usual. The appliance can emit an odour
and smoke. This is normal. Make sure
that the airflow in the room is sufficient.
5. HOB - DAILY USE
WARNING!
Refer to Safety chapters.
5.1 Heat setting
Sym‐
bols
Function
Off position
Keep warm
1 - 9 Heat settings
Use the residual heat to
decrease energy
consumption. Deactivate the
cooking zone approximately
5 - 10 minutes before the
cooking process is
completed.
Turn the knob to a necessary heat
setting.
To complete the cooking process, turn
the knob to the off position.
ENGLISH 9
Comentarios a estos manuales