Electrolux EOB9851VAX Manual de usuario Pagina 57

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 60
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 56
Problem Possible cause Remedy
Water comes out of the
water drawer after you car‐
ry it or put it inside the ap‐
pliance.
You did not assemble the
lid of the water drawer cor‐
rectly.
Assemble the lid of the wa‐
ter drawer correctly.
Water comes out of the
water drawer after you car‐
ry it or put it inside the ap‐
pliance.
You did not assemble the
wave-breaker correctly.
Assemble the wave-break‐
er in the body of the water
drawer correctly.
The appliance does not re‐
tain the water drawer after
you push it on the cover.
You did not fully press the
water drawer body.
Insert the water drawer
body in the appliance by
pushing it until it reaches
to the end.
The water drawer is diffi‐
cult to clean.
You did not remove the lid
and the wave-breaker.
Refer to "Cleaning the wa‐
ter drawer".
The descaling procedure is
interrupted before it finish‐
es.
There was a power cut. Repeat the procedure.
The descaling procedure is
interrupted before it finish‐
es.
The function was stopped
by the user.
Repeat the procedure.
There is no water inside
the grill- / roasting pan af‐
ter the descaling proce‐
dure.
You did not fill the water
drawer to the maximum
level.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The grill- / roasting pan is
on a wrong shelf position.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roast‐
ing pan on the first shelf
position.
The cleaning function is in‐
terrupted before it finishes.
There was a power cut. Repeat the procedure.
The cleaning function is in‐
terrupted before it finishes.
The function was stopped
by the user.
Repeat the procedure.
There is too much water on
the bottom of the cavity af‐
ter the end of the cleaning
function.
You sprayed too much de‐
tergent in the appliance
before the activation of the
cleaning cycle.
Cover all parts of the cavity
with a thin layer of the de‐
tergent. Spray the deter‐
gent evenly.
There is no good perform‐
ance of the cleaning proce‐
dure.
The initial oven cavity tem‐
perature of the steam
cleaning function was too
high.
Repeat the cycle. Run the
cycle when the appliance
is cold.
ENGLISH 57
Vista de pagina 56
1 2 ... 52 53 54 55 56 57 58 59 60

Comentarios a estos manuales

Sin comentarios