Electrolux FAC124P1A Instrucciones de operaciones descargar pdf (Pagina 101)

Section 4 Component Teardown

4-41

Compressor Removal

To remove the capillary tube assembly:

1. Disconnect power supply from unit.

2. Remove the front panel and cabinet wrapper/sleeve.

3. Discharge capacitor. To discharge the high voltage

capacitor, wait for 60 seconds and then short-circuit

the connection of the high-voltage capacitor (that

is the connecting lead of the high-voltage rectifier)

against the chassis with the use of an insulated

screwdriver.

4. Disconnect compressor electrical leads from control

board and capacitor. Feed wire leads through access

hole in control panel bulkhead into compressor area.

5. Attach an approved self tapping line tap valve to the

process tube. Connect refrigerant recovery system

to tap valve. Turn on recovery system, open the

line tap valve, and allow refrigerant to flow into an

approved tank.

6. Disconnect the compressor inlet line above the

accumulator. Disconnect discharge line one inch

from the outlet.

7. Use a 13mm socket or wrench and remove the 3

nuts securing the compressor to the unit base.

(See Figure 4-106)

8. R

emove the compressor electrical components by

using an 8mm socket or wrench and remove the nut

securing the cover to the top of the compressor.

Evaporator

Figure 4-106.

Condenser

Compressor

Nuts

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 139 140

Sin comentarios

Electrolux FAC124P1A Instrucciones de operaciones Pagina 101