Electrolux FAC124P1A Instrucciones de operaciones descargar pdf (Pagina 97)

Section 4 Component Teardown

4-37

Power Cord, Capacitor and Anion Generator

Removal

The power cord is secured to the unit frame with

two P-clamps and screws. The capacitor and anion

generator are secured with a single screw.

To remove the power cord:

1. Disconnect power supply from unit.

2. Remove the front panel and cabinet wrapper/sleeve.

Remove the control panel from its installation

position but do not disconnect from wire harness.

3. Discharge capacitor.

4. Extract the two screws securing the power cord

P-clamp at the base of the unit. (See Figure 4-95)

5. Extract the screw securing the P-clamp inside the

compartment. (See Figure 4-95)

6. Extract the top ground screw and remove the ground

wire lead for the power cord. (See Figure 4-95)

7. Disconnect the black and white wire leads of the

power cord from the control board. Power cord is

now free.

To remove the capacitor:

4. Follow steps 1-3 above.

5. Disconnect the wire leads from the capacitor.

6. Extract the capacitor mounting screw. Remove the

mounting strap and the capacitor is free.

(See Figure 4-95)

To remove the anion generator:

4. Follow steps 1-3 above.

5. Cut or remove straps securing the ionizer cable to

the unit.

6. Extract the bottom ground screw and remove the

ground wire lead for the anion generator. (See Figure

4-95)

7. Disconnect the black and white wire leads from the

control board that go to the anion generator.

8. Extract the anion generator mounting screw. Anion

generator is now free. (See Figure 4-95)

To discharge the high voltage capacitor, wait for 60

seconds and then short-circuit the connection of the

high-voltage capacitor (that is the connecting lead of

the high-voltage rectifier) against the chassis with the

use of an insulated screwdriver.

CAUTION

Capacitor

Anion

Generator

Ground Screws

Screw

Power

Cord

Ionizer

Cable

Capacitor

Mounting Screw

Control

Board

To Fan &

Compressor

Screw

Screws

Figure 4-95.

Not all wires shown for clarity.

BLUE

CN1

CN4

CN3

BLACK

CONTROL BOARD

EVAPORATOR SENSOR

AMBIENT SENSOR

WHITE

BLUE

GREEN

Y/G

FAN MOTOR

BLUE

DISPLAY BOARD

COM

N.O.

RY6

CN2

RED

BLACK

ANION

Y/G

COMP

RED

Y/G

SUPPLY

POWER

WHITE

RED

YELLOW

CAPACITOR

ANION

Figure 4-96.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 139 140

Comentarios a estos manuales

Sin comentarios

Electrolux FAC124P1A Instrucciones de operaciones Pagina 97

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Electrolux FAC124P1A