
Section 4 Component Teardown
4-12
Condenser Fan Blade and Shroud Removal
To remove the condenser fan blade and shroud:
1. Disconnect power supply from unit.
2. Remove the front panel assembly. Pull the unit from
the cabinet wrapper/sleeve.
3. Remove the condenser fan assembly from the unit.
4. Use a 13mm socket or wrench and remove the left
hand thread nut securing the condenser fan blade to
the motor shaft. (See Figure 4-26)
5. Pull the lock washer and washer from the motor
shaft, then pull the fan blade from the motor shaft.
6. With the fan blade removed, the condenser fan
shroud can be removed from the condenser fan
assembly.
Fan Motor Removal
To remove the fan motor:
1. Disconnect power supply from unit.
2. Remove the front panel assembly. Pull the unit from
the cabinet wrapper/sleeve.
3. Remove the condenser fan assembly from the unit.
4. Remove the blower wheel and fan blade.
5. Use a 10mm socket or wrench and remove the three
nuts securing the condenser fan motor to the right
partition bulkhead. Lift condenser off mounting
studs. (See Figure 4-27)
Compressor Removal
To remove the fan motor:
1. Disconnect power supply from unit.
2. Remove the front panel assembly. Pull the unit from
the cabinet wrapper/sleeve.
3. Attach an approved self tapping line tap valve to the
process tube. Connect refrigerant recovery system
to tap valve. Turn on recovery system, open the
line tap valve, and allow refrigerant to flow into an
approved tank.
4. Disconnect the compressor inlet line above the
accumulator. Disconnect discharge line one inch
from the outlet.
5. Use a 13mm socket or wrench and remove the 3
nuts securing the compressor to the unit base.
(See Figure 4-28)
6. Remove the compressor electrical components by
using an 8mm socket or wrench and remove the nut
securing the cover to the top of the compressor.
Figure 4-26.
Figure 4-27.
Figure 4-28.
10mm Nuts
13 mm Nut
13 mm
Nuts
Process Tubes
Comentarios a estos manuales