
Section 2 Installation
2-19
12. To remove front:
1. Remove the two front retaining screws from the
front frame. (See Figure 2-58)
2. Press firmly on each side of the metal case close
to the front approximately 2/3 of the way down.
3. While pressing on the sides of the metal case,
gently pull the front out and lift up to release it
from the case.
4. Disconnect the electrical coupler plug.
13. Place the air conditioner in the window opening. It
should sit on the platform assembly so that the
window panel frame and the cabinet side channels
are against the top and side window jambs. Side
channels should overlap side window jambs equally.
14. Drill two 9/64-inch diameter pilot holes in the top
window jamb in line with the partially plugged holes
in the panel frame. Secure panel fame to window
jamb with two #8-32 x 3/4-inch self-threading
screws. If additional holding is necessary, two
screws may be used on the sides of panel frame as
well.
15. Drill two screw-clearance holes in the cabinet side
channels (near bottom) and two 9/64-inch diameter
pilot holes in the side window jambs. Secure the
cabinet side channels to the window jambs with two
#8-32 x 3/4-inch self-threading screws. When doing
this, be careful not to twist the side channel seals
with the screws.
16. To replace the front:
First reconnect the coupler plugs, move the exhaust
control positioned through the front to the proper
location. Gently push the front into position on the
cabinet. It should click into place. Then replace the
retaining screws that holds the panel in place.
DO NOT push or pull air direction louvers.
NOTE
Inserting screws will prevent the air conditioner from
being pushed into the room.
NOTE
Figure 2-58.
Figure 2-59.
Front
Retaining
Screw
Comentarios a estos manuales