Electrolux FAC124P1A Instrucciones de operaciones descargar pdf (Pagina 74)

Section 4 Component Teardown

4-14

Model FAZ (Medium Duty Slider) Series

The Model FAZ is similar in design and components to the Model FAM and FAS series. The Model FAZ illustrated here

has the heat option.

Filter And Front Panel Assembly Removal

1. Disconnect the power supply from unit.

2. Open the front grille panel by using both hands,

grabbing along the sides of the unit and pulling the

top of the front grille panel away from the unit until

the retaining tabs release from the front panel. Tilt

the front grille panel away from the unit.

3. Grasp the filter in the center and pull out of unit.

4. Remove front grille panel by pulling the front grille

panel upwards till the hinges can be pulled out from

the slots at the bottom corners of the unit frame.

5. Extract the screw from each side of unit securing the

front panel to the unit frame. (See Figure 4-32)

6. Remove the front panel by pulling the front panel

outer edges away from the unit frame until the tabs

are free of the slots. (See Figure 4-32, Arrows show

tab locations) Release the side tabs first then lift the

front panel upwards until the front panel is free.

Cabinet Wrapper/Sleeve Removal

To remove the cabinet wrapper/sleeve:

1. Disconnect the power supply from unit.

2. Remove the front panel assembly.

3. Extract the two shipping screws securing the cabinet

wrapper/sleeve to the unit base.

4. At the front of the unit is a handle to pull the air

conditioner assembly from the cabinet wrapper/

sleeve. Pull the assembly straight out until free of

the cabinet wrapper/sleeve.

Control Box Cover Removal

To remove the control box cover:

1. Disconnect power supply from unit.

2. Remove the front panel assembly and cabinet

wrapper/sleeve.

3. Extract screw securing the cover to the control box.

4. Lift right side of cover slightly upwards then push to

the left to release tab inserted into the control box.

Figure 4-31.

Figure 4-33.

Cover

Screw

Control Box

Mounting

Screw

Fan

Figure 4-32.

Retainer

Screw Screw

Due to the number of models within the series, some teardown procedures, such as locations and number of

fasteners, and location of electrical system components, may vary from the descriptions given in this section.

Always use the wiring diagram attached to the unit for all electrical connections.

NOTE

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 139 140

Comentarios a estos manuales

Sin comentarios

Electrolux FAC124P1A Instrucciones de operaciones Pagina 74

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Electrolux FAC124P1A