Electrolux FAC124P1A Instrucciones de operaciones descargar pdf (Pagina 37)

Section 2 Installation

2-7

3. Insert top and bottom legs of window filler panel

frame into channel in the to angle and bottom rail.

Do both sides.

4. Insert washer head locking screws (2) into holes in

top leg of filler panel frame. Do not totally tighten.

Allow leg to slide freely. (See Figure 2-20)

Place Cabinet in Window

1. Open window and mark center of window stool.

2. Place cabinet in window with bottom stool angle

firmly seated over window stool as shown. Bring

window down temporarily behind top angle to hold

cabinet in place.

3. Shift cabinet left or right as needed to line up center

of cabinet on center line marked on stool.

4. Fasten cabinet to window stool with 2 screws into

holes. (You may wish to pre-drill pilot holes.)

(See Figures 2-21 & 2-22)

5. Add bottom rail seal over screws to window stool.

Install Support Bracket

1. Hold each support bracket flush against outside of

sill and tight to bottom of cabinet as shown below.

Mark brackets at top level of sill, then remove.

(See Figure 2-23)

2. Assemble sill angle bracket to support brackets at

the marked position, as shown. Hand tighten, but

allow for any changes later. (See Figure 2-24)

3. Install support brackets (with sill angle brackets

attached) to correct hole in bottom of cabinet as

shown. (See Figure 2-25)

4. Tighten all 6 bolts securely.

Figure 2-21.

Bottom

Rail Seal

3/4" Long Hex-

Head Screw

Left

Locknut

Sill Angle

Bracket

Flat Head Bolt

2 Each Req'd For Each

Support Bracket

1/2" Long Screws

And Locknuts

Right

1/2" long screws

and locknuts

Figure 2-22.

Figure 2-24.

Figure 2-25.

Figure 2-23.

Stool

Angle

Mark

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 139 140

Comentarios a estos manuales

Sin comentarios

Electrolux FAC124P1A Instrucciones de operaciones Pagina 37

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Electrolux FAC124P1A