Electrolux FAC124P1A Instrucciones de operaciones descargar pdf (Pagina 69)

Section 4 Component Teardown

4-9

Compressor Capacitor Removal

The compressor capacitor is located under a cover

mounted to the back of the scroll blower duct assembly.

To remove the compressor capacitor:

1. Disconnect power supply from unit.

2. Remove the front panel assembly. Pull the unit from

the cabinet wrapper/sleeve.

3. Extract the two screws securing the capacitor cover

to the unit frame. (See Figure 4-17)

4. Discharge capacitor.

To discharge the high voltage capacitor, wait for 60

seconds and then short-circuit the connection of the

high-voltage capacitor (that is the connecting lead of

the high-voltage rectifier) against the chassis with the

use of an insulated screwdriver.

CAUTION

5. Disconnect the wire leads from the capacitor.

6. Extract the screw securing the capacitor mounting

strap to the cover. Remove capacitor from unit.

(See Figure 4-18)

Condenser Fan Cover Removal

To remove the condenser fan cover:

1. Disconnect power supply from unit.

2. Remove the front panel assembly. Pull the unit from

the cabinet wrapper/sleeve.

3. Extract the screw from each side of the cover.

(See Figure 4-19)

4. Extract the three screws from the front of the cover

and lift off condenser fan assembly.

Figure 4-17.

Figure 4-18.

Figure 4-19.

Screws

Screw

Screw Screw

Screws

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 139 140

Sin comentarios

Electrolux FAC124P1A Instrucciones de operaciones Pagina 69