Electrolux FAC124P1A Instrucciones de operaciones descargar pdf (Pagina 85)

Section 4 Component Teardown

4-25

Front Blower Housing And Heater Assembly

Removal (Heater Equipped Models)

To remove the front blower housing and heater

assembly:

1. Disconnect the power supply from unit.

2. Remove front panel and cabinet wrapper/sleeve.

3. Remove the control box. Remove wire leads for the

duct thermistor at the control board.

4. Cut insulation to free front blower housing from the

rear section of the blower housing.

5. Carefully pull front blower housing upwards while

feeding the heater wire harness through the access

hole until free of the evaporator.

6. Extract two screws from each side of the evaporator

securing the heater assembly and front scroll cover

to the evaporator flange. (See Figure 4-63)

7. Pull the heater assembly and front scroll cover

upwards until free of evaporator. There may be

insulation glue between the evaporator and front

scroll cover. Be sure to replace the insulation when

reassembling the unit.

8. Lay the heater and front scroll cover on a flat

surface and extract the two screws securing the

heater assembly to the front scroll cover.

(See Figure 4-64)

9. Slide heater assembly to the left until the metal

legs are free of the retaining slots then pull heater

assembly off of front scroll cover.

Figure 4-64.

Screws

If the thermal limiter and/or the thermostat are

defective, the entire heater assembly must be replaced.

NOTE

Figure 4-63.

Screws

Left Side Right Side

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 139 140

Sin comentarios

Electrolux FAC124P1A Instrucciones de operaciones Pagina 85