Electrolux FAC124P1A Instrucciones de operaciones Pagina 82

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 140
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 81
Section 4 Component Teardown
4-22
Model FAH (Thru the Wall) Series
Filter And Front Panel Assembly Removal
1. Disconnect the power supply from unit.
2. Grab filter handle at top center of the front grille.
Pull out, then upwards to remove filter.
(See Figure 4-54)
3. Extract the two screws securing the front panel to
the unit. Screws are visible with the filter removed.
(See Figure 4-55)
4. Using a putty knife, carefully pry out the side and
top retaining clips from the slots cut in the cabinet
wrapper. (See Figure 4-55, Arrows show tab
locations)
5. Pull front panel from front of unit
Cabinet Wrapper/Sleeve Removal
To remove the cabinet wrapper/sleeve:
1. Disconnect the power supply from unit.
2. Remove the front panel assembly.
3. Extract the screws from each side of unit. Extract
the screws securing the fan guard and cabinet
wrapper/sleeve to the back of the unit. Remove fan
guard from back of unit. (See Figure 4-56)
4. Lift cabinet wrapper/sleeve off of the unit.
User Interface Removal
To remove the user interface:
1. Disconnect power supply from unit.
2. Remove the front panel assembly.
3. Disconnect wire harness at disconnect.
4. Extract the four screws securing user interface to
front panel. (See Figure 4-57)
5. Remove the user interface board by extracting the 4
screws securing the board to the housing.
(See Figure 4-58)
Check
Filter
Sleep
Tem p / T i m e r
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
Auto Temp
Med
Hi
Lo
Heat
Energy Saver
Cool
Fan Onl y
Figure 4-54.
Left SideRight Side
Back of Unit
Figure 4-56.
Screws
Check
Filter
Sleep
Temp/Timer
Tem p / T i m e r
Remote
Sensing
Timer
Mode
Fan
Speed
Auto Temp
Med
Hi
Lo
Heat
Energy Saver
Cool
Fan Onl y
Figure 4-55.
Pull Out
Filter
Screws
Screws
Screws
Check
Filter
Sleep
Temp/Timer
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
Auto Temp
Med
Hi
Lo
Heat
Energy Saver
Cool
Fan On ly
Figure 4-57.
Screw
Thermistor
Due to the number of models within the series, some
teardown procedures, such as locations and number of
fasteners, and location of electrical system components,
may vary from the descriptions given in this section.
Always use the wiring diagram attached to the unit for
all electrical connections.
NOTE
Vista de pagina 81
1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 139 140

Comentarios a estos manuales

Sin comentarios